Could not find the Recovery Environment in Windows 11/10

Download PC Repair Tool to chop-chop notice & set Windows errors automatically

If the Windows Recovery Environment (WinRE) is not working and you lot receive a bulletin Could not observe the Recovery Environment in Windows xi/10, and then this post may be able to aid you. Sometimes you might face an event where y'all cannot boot into Windows RE. There tin be multiple reasons, but take you e'er wondered where Windows RE is available on your computer?

Windows Recovery Environment not working

During Windows Setup, Windows initially places Windows RE Prototype file in the installation partition. If yous accept installed Windows on C drive, it volition be available at the C:\Windows\System32\Recovery or C:\Recovery folder. It's a hidden folder. Later, the system copies this image file into the recovery tools partitioning. It makes sure that ane can kick into recovery if there is a problem with the bulldoze-partition.

Could not find the Recovery Environment

The error usually happens when either Windows RE is disabled or the Winre.wim file is corrupt. So if you become an mistake where the Windows Recovery Environment is not working, here is how yous can fix it:

1] Enable Windows RE or WinRE

Open PowerShell or Command Prompt with admin privileges.
Blazon reagentc /info and striking Enter.
If the output says Condition as enabled, you are all fix.

To enable Windows RE, type reagentc /enable and hit Enter. A success message at the finish volition ensure Windows RE is bachelor.

For your information, to disable it, one uses reagentc /disable.

ii] Fix Winre.wim corrupted or missing

In either of the case, you lot will demand a new copy of Winre.wim. Y'all can search on the figurer, or y'all can find the file on another similar computer where Windows RE is working. Once you locate the file, copy it from another computer. You lot need to set up the image path to a new location.

Next, execute the following command to change the path of the WIM file to the new location. The steps should be used when the file-path of Windows RE file is different from the usual spot.

Reagentc /setreimage /path C:\Recovery\WindowsRE

If the file is corrupted, you lot tin can copy it from another computer. Re-create it to the C:\Recovery path so fix the path again. Make sure to verify the path with reagentc /info command.

The Recovery folder is hidden, and not accessible using Windows File Explorer. Also, the WINRE folder inside it is hidden. You will have to use PowerShell or Command Prompt to access them. Before copying, make sure to disable WINRE on that calculator, and enable it subsequently.

3] Invalid WinRE Reference in Windows Boot Loader

Windows Kick Loader determines if it has to load Windows RE. It is possible that the loader is pointing to an incorrect location.

Open PowerShell with admin privileges, and execute this command:

bcdedit /enum all

Look for an entry in Windows Kick Loader identifier set equally Current.

In that section, find "recoverysequence" and note the GUID.

Over again, in the result, search for Windows Boot Loader identifier fix as the noted GUID.

Make sure that thedeviceandosdevice items show the path for the Winre.wim file and they are the aforementioned. If non, we volition have to signal the current identifier to one which has the same.

One time yous find the new GUID, run the command:

bcdedit /set up {current} recoverysequence {GUID_which_has_same_path_of_device_and_device}

See if this resolves the issue.

iv] Create a Recovery Media

Download Windows ten ISO file using the Media Creation Tool. Create a recovery drive and so the needful. Check if this resolves the issue.

All the best.

Ashish is a veteran Windows, and Xbox user who excels in writing tips, tricks, and features on it to improve your 24-hour interval to solar day experience with your devices.